![]() It is not possible to loft disjoint or crossing loops.Otherwise an invalid loft can be created where inner and outer walls cross. the loft is supposed to have holes, then the order in which the sketch geometry is created, should be the same for all sections: Either start all sections with the inner geometry or start them all with the outer. If the sketch has inner geometry, i.e.A cross-section cannot lie on the same plane as the one immediately preceding it.This would violates the CAD kernel's definition of a 3D object. Otherwise the loft body would consist of two solids connected at a single point. Vertices can only be either the start or end of a loft.You can loft from or toward a single vertex from a sketch or the body.For example, for a loft between a rectangle and a circle, the circle should be broken down into 4 connected arcs. To better control the shape of the loft, it is recommended that all cross-sections have the same number of segments.Data Profile: the see base profile object of the loft.If set to true, cleans the solid from residual edges left by features. Data Sections: lists the sections used.Data Label: name given to the operation, this name can be changed at convenience.Closed: makes a transition from the last cross-section to the first, creating a loop.If not checked, transitions will be smooth. Does not apply to a loft with two cross-sections. Ruled surface: makes straight transitions between cross-sections.The first or last selection can also be a face of a 3D object ( introduced in version 0.20).(You can change the section order any time later in the loft dialog by dragging sections in the list to the desired position. Also here the selection order is important: The sketch selected as second will become the first loft section, the one selected as third becomes the second section and so on. The sketches selected after the first one will become the loft sections.The sketch selected at first will become the base profile object in the next step. ![]() It is hereby important in what order you select them: ![]() Repeat to select more sketches in the order you want them to be lofted through.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |